Hello ML team,
First, I would like to congratulate you for your excellent firmware
For me bests features are : Peak focus, movie restart + sound level meter and intervalometer.
Nevertheless, I've noticed something with this b4a release of ML which can scare 70D's owners (I couldn't find any topic about that but perhaps I dit a wrong search).
After installed and ran ML for a while, I putted a new blank 16Go SD card in my 70D, but, here noting happened : I was unable to switch on the camera !
If I remove the SD card, it started in "100% look like" Canon's firmware, and of course "No card" appears.
I tried with several (blank) SD cards : Same issue => No boot, no SD red light, nothing... even no top lcd or TFT display... Glups !
So I wrote back in one of my SD, ML b4a, then all worked fine again.
So nothing bad... but a bit confusing and scaring.
If this is a normal behavior (not a bug), for me it should be mentioned on the how-to on this topic
(Like : Warning After installing ML, if you use a blank SD card, you won't be able to start your camera again. You must install ML files and dirs on every SD you are using with your camera while ML is installed on it").
Thanks !
Matthieu
First, I would like to congratulate you for your excellent firmware
For me bests features are : Peak focus, movie restart + sound level meter and intervalometer.
Nevertheless, I've noticed something with this b4a release of ML which can scare 70D's owners (I couldn't find any topic about that but perhaps I dit a wrong search).
After installed and ran ML for a while, I putted a new blank 16Go SD card in my 70D, but, here noting happened : I was unable to switch on the camera !
If I remove the SD card, it started in "100% look like" Canon's firmware, and of course "No card" appears.
I tried with several (blank) SD cards : Same issue => No boot, no SD red light, nothing... even no top lcd or TFT display... Glups !
So I wrote back in one of my SD, ML b4a, then all worked fine again.
So nothing bad... but a bit confusing and scaring.
If this is a normal behavior (not a bug), for me it should be mentioned on the how-to on this topic
(Like : Warning After installing ML, if you use a blank SD card, you won't be able to start your camera again. You must install ML files and dirs on every SD you are using with your camera while ML is installed on it").
Thanks !
Matthieu