Just found this forum, today. Hope to obtain a solution to the 29:59 minute limitation when recording video. Essential to an objective I have of recording our church services and making the videos available to our members who are at home and unable to get out.
I have a Canon ESO T4i. It is about 2-3 years old. I am attempting to install ML, but all my attempts result in failure at the 4% mark while the Firmware Update Program is running. At that point, I receive the following message:
"Update file error
Please check the memory
card and reload the
battery and try again."
The camera was using firmware version 1.0.5. I installed version 1.0.4 after reading here that the current version of ML requires 1.0.4 (please correct me if I am wrong).
Initially, I was using a 200-GB card, but after reading some past posts about possible problems with anything above 32-GB, I attempted to install ML from a 2-GB card. Still not successful.
I performed a low level format of the card (using the camera) before copying the ML files to it. During all this, I noticed the camera formats the card using FAT despite the manual saying exFAT is used. As a result, I attempted installing ML using the card formatted as FAT, then exFAT. Still no success with the same error message.
I also attempted to use the last three ML posted files. I got as far as using the nightly build posted MAR 12, 2017. Same unsuccessful results.
At this point, I am at a loss as to what to try next. Any guidance would be greatly appreciated.
Thank you!
Gerald
I have a Canon ESO T4i. It is about 2-3 years old. I am attempting to install ML, but all my attempts result in failure at the 4% mark while the Firmware Update Program is running. At that point, I receive the following message:
"Update file error
Please check the memory
card and reload the
battery and try again."
The camera was using firmware version 1.0.5. I installed version 1.0.4 after reading here that the current version of ML requires 1.0.4 (please correct me if I am wrong).
Initially, I was using a 200-GB card, but after reading some past posts about possible problems with anything above 32-GB, I attempted to install ML from a 2-GB card. Still not successful.
I performed a low level format of the card (using the camera) before copying the ML files to it. During all this, I noticed the camera formats the card using FAT despite the manual saying exFAT is used. As a result, I attempted installing ML using the card formatted as FAT, then exFAT. Still no success with the same error message.
I also attempted to use the last three ML posted files. I got as far as using the nightly build posted MAR 12, 2017. Same unsuccessful results.
At this point, I am at a loss as to what to try next. Any guidance would be greatly appreciated.
Thank you!
Gerald