Hello,
I installed Dokan and MLVFS_x86 from the first page (running windows 7 64bits).
At first everything seemed to work fine, I can mount the dng files and open them in After Effects. But when I apply settings in ACR inside After Effects, they are only applied to the first frame, not to the whole sequence. It works fine if I put dng files in a regular folder without using MLVFS.
I then realized that I cannot copy a file onto the drive that is mounted, which probably explains that AE can not copy metadata files or write inside the dng files, therefore the settings are applied only to the first frame of the sequence.
I noticed other people here had the same problem, but could not find a clear solution in this thread. Should I use newer versions that are not released yet? If so where do I find them and how do I proceed?
Thanks.
I installed Dokan and MLVFS_x86 from the first page (running windows 7 64bits).
At first everything seemed to work fine, I can mount the dng files and open them in After Effects. But when I apply settings in ACR inside After Effects, they are only applied to the first frame, not to the whole sequence. It works fine if I put dng files in a regular folder without using MLVFS.
I then realized that I cannot copy a file onto the drive that is mounted, which probably explains that AE can not copy metadata files or write inside the dng files, therefore the settings are applied only to the first frame of the sequence.
I noticed other people here had the same problem, but could not find a clear solution in this thread. Should I use newer versions that are not released yet? If so where do I find them and how do I proceed?
Thanks.