Messages

Ok, I found out what actually fixed the issue. 

It seems that a full reset is needed before it would do anything.  By removing the battery for 30 seconds and restarting with ML SD Card back into the camera, I was able to "un-brick" the camera.  Once the card with Magic Lantern was run and the camera was reset, the camera operated normally.  Normally means that the Camera would start with or without an SD card.   

I hope that this is something that can help others with the same issue.

Thank you.

I think I just bricked my Canon 6D.

Here is the steps that I did:

1. I updated my camera firmware (Canon) from 1.1.4 to 1.1.6.  Sucessful
2. I removed the Canon update from my SD card and put the ML files on it.
3. I ran the ML update and it finally said to restart my camera.
4. I removed the card, moved the ML files to my laptop machine. 
5. I then replaced the SD card and turned my camera on.
6. Nothing happens.  It seems very dead. 

Is there hope?  Or is my camera "bricked"?   

HELP!