Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - kriso

#1
This method works perfectly fine with the 60D or the T3i shown in this video, but it's not working with the 70D. It's the Digic5 processor that  makes the things complicated. ML for 70D does not have the "Headphones monitoring" feature. It's not working, I have tried already. Only works with my 60D...
#2
Quote from: kriso on December 16, 2015, 06:19:51 PM
On the headphone monitoring: I use canon factory made cable  (a/v out to cinch) + 3.5 mm adapter to plug the headphones. Im only getting loud noise in my ears and the LCD screen turns immediately black after I plug the cable into the dslr. It dosen't matter modes. Just the noise seems to change a bit every time I press any of buttons.

Canon 70D - 70D.111A 26th November: Beta-2b
@kriso --
The screen is going to go blank because you are plugging into an "Audio / Video" jack, so it switches off the built-in screen. 

The headphones are not as easy as you are trying to make it.  That jack has a mono line-level output for audio.  First problem is that your impedance is going to be way off by trying to plug directly into headphones.  Secondly, if you are not using an adapter made specifically for this purposes, you are shorting two of the contacts together that shouldn't be.  Thirdly, there is no proper amplification to drive the headphones inductor.   

You should be very careful, as stated you are potentially shorting out connections.  The 70D ML firmware is not setup to allow headphone monitoring, it is something that I've been told might just not be possible with the Digic 5 processor.  Also I will point out that the cable to allow headphone monitoring on the cameras that have this hack in ML, still use a specially modified Canon cable to allow it to work and make the proper connections.  Just my two cents of advice.

Audio headphone monitoring with this cable is not posible by the moment, I've been through this guys...
#3
Im aware that there is no Headphone monitoring on 70D yet. Did what I did out of ignorance and curiosity...
This is the video tutorial I've watched first: https://www.youtube.com/watch?v=BnEtj5l3acs
In the begining of it the host lists the camera models which work in this fashion and the 70D is NOT included. But I have 60D, should I try this with it?

Canon 70D - 70D.111A 26th November: Beta-2b
#4
On the headphone monitoring: I use canon factory made cable  (a/v out to cinch) + 3.5 mm adapter to plug the headphones. Im only getting loud noise in my ears and the LCD screen turns immediately black after I plug the cable into the dslr. It dosen't matter modes. Just the noise seems to change a bit every time I press any of buttons.

Canon 70D - 70D.111A 26th November: Beta-2b
#5
Any idea if we are far away from headphone monitoring feature (using the a/v out to monitor audio on your headphones with the canon cable while video rec) and working fps override for the 70D?

Canon 70D - 70D.111A 26th November: Beta-2b
#6
Hey guys! I have 70D and I use ML on 64bg card and I'd just like to thank all of you developers and testers who invest their knowledge and time into this software! Seems like 70D dosen't lends itself easy to hacking from what I read. Im so exited about the FPS override (timelapse) and Audio meters features. Wish you guys good luck, I shall report if anything occurs here!