Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - ae2

#1
Thank you guys. I will document the case on video, however, I have a planned tour for the next week (I was happy to try ML in the first time, I am a HDR shooter). When I come back I will allocate more time for the resolution. In the meantime I will be stuck with the hated 3 frames bracketing. Shame yourself Canon.
THX for your help.
#2
Yes, I reinstalled the native 2.1.2 again for sure (fresh download). The camera and the installation process behave quite probabilistically. Sometimes the whole firmware installation hangs up (with red LED on) before the sensor cleaning in the boot process could start and the camera becomes unresponsive, only battery reset helps. Sometimes the ML installation process seems to finish normally, red LED is off and the sensor cleaning cycle starts ... then nada. In this case the camera is responsive, and when I bring up the Canon menu it says that current firmware is "2.1.2-ml". The ML menu, however, cannot be actuated by the trash button. When resetting (off-on cycle) the firmware reverts to the original 2.1.2. No idea.
#3
Thank you, I read the guide thoroughly and made everything recommended. No result, ML does not want to boot in my camera. Lost my hope.
#4
I am trying to install the newest NB on my 5D2 following the instructions, accurately. After preparing the card with the ML files I press the install new firmware version button as required. Then, the install new firmware message appears very shortly and the red LED blinks quickly for around 3 seconds and the process hangs up indefinitely. Complete black out. The camera is not responsive. Removing the battery the camera boots up normally and the Canon 2.1.2 seems untouched. Any idea what can be the problem?