1
Archived porting threads / Re: Canon 6D / Firmware 1.1.3
« on: June 12, 2015, 12:02:14 AM »
Thanks @sapporo, sounds like that may well be the issue. I'll the time as you suggest, cheers
News:
Etiquette, expectations, entitlement...
@autoexec_bin | #magiclantern | Discord | Reddit | Server issues
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Archived porting threads / Re: Canon 6D / Firmware 1.1.3 - Dual ISO inconsistencies
« on: June 09, 2015, 10:59:37 AM »
(searched this thread but not seen this mentioned)
I've been shooting with dual ISO for many months on my 6D. Normally not noticed any issues. This weekend I went out and shot a bunch of images, using ISO 100/1600, with my camera mounted on top of a pole and remotely triggered using Pocket Wizards. When I reviewed the photos later, I noticed some did not shoot as dual ISO.
They seemed to perhaps be related to waking the camera up after a couple of minutes, and the first burst is capturing in 'normal' mode, before it switches on dual ISO. I missed a few shots (or more properly, I got them but they're shot a couple of stops under) which is a bit of a shame but hey…but as I've never come across this inconsistency before I wanted to post it here in case this is known.
My guess is that the half-press to wake is enough to get the camera ready for shooting, but there's some kind of lag/delay before a command kicks in to enable dual ISO for the remainder of the burst (or for a second burst). Camera was set to continuous shoot mode.
FYI Build was magiclantern-Nightly.2015May03.6D113
I've been shooting with dual ISO for many months on my 6D. Normally not noticed any issues. This weekend I went out and shot a bunch of images, using ISO 100/1600, with my camera mounted on top of a pole and remotely triggered using Pocket Wizards. When I reviewed the photos later, I noticed some did not shoot as dual ISO.
They seemed to perhaps be related to waking the camera up after a couple of minutes, and the first burst is capturing in 'normal' mode, before it switches on dual ISO. I missed a few shots (or more properly, I got them but they're shot a couple of stops under) which is a bit of a shame but hey…but as I've never come across this inconsistency before I wanted to post it here in case this is known.
My guess is that the half-press to wake is enough to get the camera ready for shooting, but there's some kind of lag/delay before a command kicks in to enable dual ISO for the remainder of the burst (or for a second burst). Camera was set to continuous shoot mode.
FYI Build was magiclantern-Nightly.2015May03.6D113
Pages: [1]