Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - jayhawker

#1
Camera-specific Development / Re: Canon 1200D
October 02, 2016, 06:42:22 PM
Just wanted to report that I was able to get the latest build (July 30) working on my 1200D. Since it took me a little searching through the thread to figure out what to do, I'll post my steps to hopefully help others.

I'm running Windows 10 and was successful in using both a 2gb & 32gb card.

1. Ensure your camera is running the 1.0.1 firmware. I wasn't at first and ran into issues. Once I updated, I had no problems.
2. Format memory card using in-camera menu.
3. Remove card and put in computer.
4. Copy the unzipped contents of the latest (July 30) build into the ROOT directory of the card (leave the others folders intact). This should be the 'ML' folder and 'autoexec.bin' file
5. Copy '1200BOOT.fir' into the root directory as well.
6. Run EOScard.exe
7. Click 'refresh' and make sure your card is detected
8. Click the ML logo and then click 'Save'. You should receive a confirmation message at the bottom.
9. Close EOScard and eject the memory card from your computer.
10. Put the card in your camera and turn it on.
11. 'Install' using the firmware update menu

Thanks to everyone that contributed, your hard work is much appreciated!
#2
Camera-specific Development / Re: Canon 1200D
May 14, 2015, 04:12:13 AM
Awesome work! I've been following the progress. I have some coding experience, but haven't delved into ML development yet. However, if you need testers I'd be happy help out.