Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - chakawa

#1
Thanks for your reply.
Yes I did.

Also, I just replaced the battery with a new one and all what's happening is it is blinking red (kind of same as it does normally) but nothing showing up on LCD and camera does not boot.

Also pls note that the camera does not do anything (not even blinking) without any CF card inserted (with new battery).

What next step should I take ? Should I re-install ML completely ?

Thanks in advance
Chakawa
#2
Hello,

My 5dmkII who had been long running with ML without probs, just froze suddenly.
I have placed the autoexec file (portable display test) on the card ; and got a long log. Don;t understand any of it and does not look like I can attach it to my post (can I ?)
Basically there was an almost non visible dark screen with dark small grey lines horizontal. And when I turn the camera off and on again, it did not repeat the display.
Then I placed the second autoexec file (LED blink test) ; and there was no blink happening.

Assuming I needed to remove the original ML Autoexec manually from the card : is that right ?

Any advice would be greatly greatly appreciated

Thanks in advance
Chakawa