Messages

Thanks for the tutorials!

Hi. I was very excited to discover and use MLVFS with my mac, and it has been a charm!!

I recently noticed when I try to mount a folder with my entire 63.98gb of .MLV data I sometimes lose frames in the .DNG's. In the browser window that pops up it also says there are less frames than I recorded. BUT, If I put one .MLV file (and all of its parts .M01, .M02..) into a folder alone and run MLVFS it gives me all the frames!

Anyone else had this happen?

If it's been answered I apologize, I read some of the discussion then skipped to the end 

aace - before I read your reply I fixed this issue by switching my HDMI monitor resolution to 480p... haha!! I think that's pretty much the same thing you did to fix it but with a different method!

I will be doing some tests later this week, but I figured I would start the thread to see if someone had an obvious answer.

The problem is the frame splitting horizontally during shots with lots of motion, be it camera or subject. I've been using MLV_REC without this problem for awhile, but for this shoot we had the camera plugged into an HDMI monitor so I'm thinking that's got to be what did it.

The set up was:
Canon 7D (magiclantern-Nightly.2015May03.7D203)
MLV_REC
23.976 fps
1728 x 972
HMDI Monitor - LILLIPUT 7" 339 IPS

I've been reading about this Global Draw option, not sure where to find it in the menu or if it was ON/OFF, could someone please explain what exactly that does!? THanks!