Messages

Sometimes ML changes Canon firmware settings, like Audio for H.264.  It may have turned off "shoot w/o lens", so check that.  Also, if all that fails, re-set all options in the config menu, change from default to shoot w/o lens, then try again.

Thanks Everyone.  I feel a little stupid now.  I had never had to set the "Shoot w/o lens" setting.  It must have come with it already enabled.  Once I found the setting, re-enabled it, and re-installed ML everything works great!  Now just to figure out how everything works!

I also, purchased a new SanDisk SDXC Pro card (32GB on sale at Best Buy for $59!!!)  JIC it was the card issue as listed in the "shutterbug" forum.  So i'll use my Microcenter (C10) cards for stills.

Again, Thank you!

Help,

So admittedly I am new to ML and TL.  I was told by a friend how awesome the builds are and how well they work for the EOSM.  Unfortunately, I came across a snag.  After installing the latest build from Jan 22, my camera would no longer take stills or video with a manual lens attached.  Even when I re-attached the original lens (Canon 18-55mm) it would not take still photos, but would take video.  If I tried using the screen one click shoot mode, it locked the camera up.

After going back and forth several times of "re-installing the 2.02 firmware (I was never prompted to uninstall ML(TL)) and doing low-level and high level card re-formats, I think ML has been uninstalled.  For the most part the camera is fully functional, no ML OSD (I never got the menu list browser) However, I still cannot use my manual lens in either still photos or video.

Have I fully uninstalled the ML firmware?  If not how can I get it off, and gain back full usage of my EOSM?  I have a shoot this weekend, and I really need to use the prime lens.

Thank You