Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ebetecos

Pages: [1]
1
Main Builds / Re: Nightly Builds - try the very latest stuff here
« on: August 30, 2014, 12:32:10 PM »
I've downloaded the newest one, and there is only autoexec.bin and ML folder. To perform the instalation firmware file is needed, which is not there. If I take the one from stable version, then there is error with fonts.dat. So from this symptoms I assume that there is missing something there, althought I'm not an expert here:)

2
Main Builds / Re: Nightly Builds - try the very latest stuff here
« on: August 30, 2014, 10:55:04 AM »
It worked. Thank You for help.
So as I undesrstand I should extract nightly build over stable release? I assumed that nightly build has everything it needs.

3
Main Builds / Re: Nightly Builds - try the very latest stuff here
« on: August 29, 2014, 02:14:30 PM »
But that is what i'm doing. I'm using autoexec.bin from "nightly build" and ML folder from "nightly build". The only thing i use from 2.3 is firmware to proceed with firmware update.

4
Main Builds / Re: Nightly Builds - try the very latest stuff here
« on: August 29, 2014, 12:56:08 PM »
600D
@nachordez 
That's what i was doing, but then i have this error: fonts.dat not found and installation stops. I have formatted it in cardeader and in camera.

5
Main Builds / Re: Nightly Builds - try the very latest stuff here
« on: August 29, 2014, 10:43:19 AM »
I would like to do that, but i nightly build there is only autoexec and ML folder, so I cannot run firmware update. Previously there was in 2.3v.

6
Main Builds / Re: Nightly Builds - try the very latest stuff here
« on: August 28, 2014, 11:31:15 PM »
OK, maybe I do something wrong.
If I install nightly build , should I have previously update firmware with magic lantern 2.3 and then boot it with card with nightly build prepared with EOScard?
Or should i add firmware file from 2.3 to niglty build and upgrade firmware from canon?
The card is at every step formatted before any new software .

7
Main Builds / Re: Nightly Builds - try the very latest stuff here
« on: August 28, 2014, 10:03:36 PM »
Hi,
I've just tried to install my first nightly build but I have error : no fonts.dat found.
It is build from 08.08.2014, i have extracted file directly to SD from winrar. What is the possible problem here? Thank You for any help.

Pages: [1]