Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - gius.prenc

#1
Camera-specific Development / Re: Canon 700D / T5i
November 21, 2013, 10:25:59 AM
Quote from: RedHerring on November 21, 2013, 07:06:12 AM
If I want to run without ML I remove the bootable flag from the SD.

....how do you do that? With the EOScard tool, by deselecting the bootable checkbox options? My problem is that I tried in this way, but then the camera does not boot....To have it work again, I am forced to make the sd card bootable again (and place back on the sd card the ML files).

Note that I do not have any .fir file on the SD card (there is no .fir file contained in the .zip archive for the nightly build for the 700D).

Thanks.

Regards,

G.
#2
Camera-specific Development / Re: Canon 700D / T5i
November 20, 2013, 11:37:09 PM
....ok, formatting again the sd card on the PC and running again the EOScard utility solved the issue.

Anyway, the issue appears again each time I format the card on the camera. In fact, the formatting process blocks with a "Writing Bootflags" message; then, I am forced to remove the battery, and when I place it back the camera does not start anymore (it hangs up on the "Firmware update" message of my previous post).

Is this behavior normal? Am I not supposed to format the card on the camera?

Also, the camera does not boot with a card with no ML on it....is this related to the bootflag "issue" stated few post above?

Thanks.

Regards,

G.
#3
Camera-specific Development / Re: Canon 700D / T5i
November 20, 2013, 11:00:20 PM
Hi;

I do not know what happened, but my 700D won't boot anymore. Even with no card inserted, it shows the following message: "Firmware update program: Update file cannot be found. Please check the memory card and reload the battery and try again". (The same message is shown also with sd card inserted.)

I just removed the sd card to upload a new version of ML, and then the camera started showing this strange behavior. What is going on? Is there a way to reset the camera?

Any help/hint would be really appreciated.

Regards,

G.
#4
Camera-specific Development / Re: Canon 700D / T5i
October 19, 2013, 01:02:08 AM
....I installed one of the compiled versions, so there was no .c file in the zip archive.

You are referring to the source code, right?

Thanks.

Regards,

G.
#5
Camera-specific Development / Re: Canon 700D / T5i
October 18, 2013, 07:38:40 PM
Hi;

I have been successfully using ML on a 600D, and today I just installed it on my new 700D.

However, I am able to run it only up to the first format operation. That is, when I format the sd card (clearly by choosing to keep ML), the operation ends saying "writing bootflags", then the camera shuts down.

When I turn it on again, I cannot start ML anymore. To be able to run it again, I need to make the SD card bootable again (I use MacBoot).

Any help on this?

Thanks.

Regards,

G.