Hi everyone!
I have tried to instal ML but failed miserably. The steps I went through were as follows (copied from this thread www.magiclantern.fm/forum/index.php?topic=8550.50)
--
low-level format the card in the camera.
on the PC, extract the 700...zip file to the sdcard.
with the card still plugged into the PC, run eoscard, check both eos_develop and bootdisk. it should list the fir file. click save. it should say "write successful"
no other steps.
put the card in the camera and turn it on. you should see the normal info screen, then the ml bars top and bottom. press the trash icon to get the ml menus.
--
So I did as the instruction suggests but for some reason the needed fir is not listed in the eoscard list, what I see is either "unified 2.3" or "ports in progress" with 1100d or 5d alpha etc, no 700d in the list
to be clear - the ML zip was extracted to the card, so there is a folder "magiclantern...etc"
any help is appreciated!
UPD sorted itself out somehow :=)
I have tried to instal ML but failed miserably. The steps I went through were as follows (copied from this thread www.magiclantern.fm/forum/index.php?topic=8550.50)
--
low-level format the card in the camera.
on the PC, extract the 700...zip file to the sdcard.
with the card still plugged into the PC, run eoscard, check both eos_develop and bootdisk. it should list the fir file. click save. it should say "write successful"
no other steps.
put the card in the camera and turn it on. you should see the normal info screen, then the ml bars top and bottom. press the trash icon to get the ml menus.
--
So I did as the instruction suggests but for some reason the needed fir is not listed in the eoscard list, what I see is either "unified 2.3" or "ports in progress" with 1100d or 5d alpha etc, no 700d in the list
to be clear - the ML zip was extracted to the card, so there is a folder "magiclantern...etc"
any help is appreciated!
UPD sorted itself out somehow :=)