Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bsbeamer

Pages: [1]
1
Camera-specific Development / Re: Canon 650D 1.0.4 [Status: Alpha]
« on: August 04, 2013, 06:21:26 PM »
Does performing a re-installation of the "official" Canon 1.0.4 firmware uninstall ML completely, or is that only performed through running the installer again with an "uninstall" command?  Would like to test on a camera and then reset/remove ML.  Have not yet used ML (personally), so sorry if this is a newbie question.

Has anyone tested the HDMI output on the 650D/T4i?  Curious if mirroring is possible.  Not necessarily "clean" output, but being able to use the internal/built-in monitor as well as an external HDMI monitor at the same time (without the internal going black).

Pages: [1]