Messages

Did you make the card bootable? And then putting on the ml files to the card? Did you do the nightly builds?

- How is the card made bootable? And why should it? Installation guide doesn't tell anything about that? I understood that Alpha 3 even can't be made boot from the card but must be uploaded everytime power is switched on?

- I formatted the card just as the installation guide tells. And then I copied the ML files I downloaded from the site (of course I first unzipped them)

- I don't do the nightly buildups. Just tryed the announced Alpha 3 for 5D mkIII.

Best Regards,
Ilari
]

Hello,

I can't get ML uploaded into my brand new 5D mkIII ? I have tryed several times, I have followed all the steps in the installation guide and in the message #1 of this thread strictly. I have firmware 1.1.3. for sure. My camera is new, I bought it two weeks ago.

Some observations:
- I have tryed two CF cards (Sandisk Extreme 60MB/s, 32 GB and 16 GB) and one SD card (Transcend 32GB SDHC) and ML only on one card at a time. Also I have tryed with only one card in the camera.

- In the first upload attempts, nothing happened exept card check counter went fast 0-100%, then camera was quiet (no red led blinking). Nothing installed.

- Then I updated firmware 1.1.3. to 1.1.3. for sure (I updated it from the http://pel.hu/down/). After this, the firmware upload to ML ends red led blinking for ever. So was the new 1.1.3. firmware even worse than my original 1.1.3. ?

Could someone tell, where to find 5DmkIII firmware 1.1.3., which would work with ML for sure?

Any other advice?

Just at the moment I would like to have ML to be able to use normal still-shutter button for video. Is this feature working on ML for 5DmkIII ?

Best Regards,
Ilari