Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - joshmonie

#1
Hi again.

Having followed the instructions, I'm now having another issue. Upon turning the camera on after the ML "success" screen, I'm getting a "scripts dir missing" message. I can then go into ML as normal, load the raw module, etc. but when I turn it on and go into live view, I cannot start raw recording.

Any ideas?
#2
Hi Guys,

I just want to get it out there that I'm a total newb before I go any further.

Ok, I'm needing some help on installing this all on my 5D2. As far as I'm aware, I download the current stable ML which is v2.3, unzip it and take just the 5D2-212.fir onto the root of my CF. Where do I find the autoexec.bin and ML folder? Can I just use the autoexec.bin and ML folder from a previous build and copy/paste the raw_rec.mo file into where it should be?

I was going to try this but was worried I'd brick the camera so thought I'd get some expert advice first!

Thanks in advance,
Josh
#3
Hi Guys,

I just want to get it out there that I'm a total newb before I go any further.

Ok, I'm needing some help on installing this all on my 5D2. As far as I'm aware, I download the current stable ML which is v2.3, unzip it and take just the 5D2-212.fir onto the root of my CF. Where do I find the autoexec.bin and ML folder? Can I just use the autoexec.bin and ML folder from a previous build and copy/paste the raw_rec.mo file into where it should be?

I was going to try this but was worried I'd brick the camera so thought I'd get some expert advice first!

Thanks in advance,
Josh
#4
Hi Guys,

I just want to get it out there that I'm a total newb before I go any further.

Ok, I'm needing some help on installing this all on my 5D2. As far as I'm aware, I download the current stable ML which is v2.3, unzip it and take just the 5D2-212.fir onto the root of my CF. Where do I find the autoexec.bin and ML folder? Can I just use the autoexec.bin and ML folder from a previous build and copy/paste the raw_rec.mo file into where it should be?

I was going to try this but was worried I'd brick the camera so thought I'd get some expert advice first!

Thanks in advance,
Josh