Messages

Is there anyway to autoreflash the firmware?

yep it takes pictures but the menu button and some of the functions don't work when in creative modes, but the menu button works when you go into the basic modes like Full auto and night mode, i still think it could be a screwed up firmware, is there a way to use the autoexec to reflash the whole firmware?

Ok Done That,
The Restore completed and restarted without the memory card,
it Was set to Japanese and i set it to English but i still have the same issue the creative zone modes don't work menu  button does nothing when you move the control to P,TV,AV,M,B,C modes i can't change iso settings nor can i change drive mode or exposure modes, but it will take a picture and write to the card you can change the aperture and shutter speed,
my gut feeling is a re flash or the firmware would sort this but as the firmware can only be installed via the menus in the creative zone that's not possible,

 

btw there was no screen display 

never might last post just finished 
here is the zip rom 

https://www.dropbox.com/s/0t3b656szkx7vt4/ROM.zip

3 mins and the red light is still on the card  how long should it take to write out the rom file ?

https://www.dropbox.com/s/13gcpe3ypunj541/LOG000.LOG

have that done

but cant attach or paste in here

There are no options in any of the available menus which allow me to do that is there a way to force a firmware install using the Autoexec ?

Hi
Have a canon 60D with Ml installed while some one was using it it stoped working , when they switched it back on No Display (Except for the Sensor clean message on start up)
When i Press menu nothng comes up , However i noticed that when i Put the camera in to The Auto Green Mode or any mode below this it works , I can Take a picture in anyof the creative modes and it writes to the card but wont display, also can change ISO or Drive modes in the creative mode,
The Canon Eos Utility See the camera if the mode is in one of the Auto Modes (green Auto, No Flash CA, ect ) but if i switch the mode to P,TV,AV,M,B,C the Eos utility will just say Busy,
because I can't access the creitive modes on the camera or even with the Eos utility I can't to a firmware reinstall ,,
I tried different memory card with and without ML on them , even without a mewmory card the issue is the same,

Any Idea out there,