Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - pontus

#1
Quote from: 1% on January 23, 2013, 08:34:50 PM
all-i has to be double the rate of ipb for same quality according to theory.

Why is that? I don't quite get all this talk about init qp's, qp1, bitrates, IP-B and what not. :P
#2
Tragic Lantern / Re: Tragic Lantern for 6D
January 29, 2013, 09:55:43 PM
Quote from: 1% on January 29, 2013, 09:36:41 PM
holy fuck holy fuck holy fuck!!!

i dumped ram with wifi on (phone connected but not displaying) and there is a 5k 4:2:2 jpeg in there... maybe several (looking at them now), its only 1.2MB

I don't quite get all that tech-talk, do you mean there is a 5k video or something? What does qp mean, i'm so confused over all these short for's.
#3
Tragic Lantern / Re: Tragic Lantern for 6D
January 25, 2013, 12:35:42 PM
I've been trying to find out on my own, but what does qp mean? It would be great if there was a terminology page available for teh n00bs :)
#4
Tragic Lantern / Re: Tragic Lantern for 6D
January 16, 2013, 07:56:23 PM
Quote from: 1% on January 16, 2013, 05:54:51 PM
its still a ways off. I should see what happens when i do this on 600d. Never thought of trying it even though its obvious.

Like 70 or 80 something is the highest I got. Not too bad but QPs are fairly high, above 10. IPB is locked to 60 without ML because of the profile.

Oh that's great even without ML.  :D When you test out the x12 (120mbps) bit rate, what card do you use? I'm thinking about getting new cards and the fastest UHS-1 cards from sandisk should do the trick, right? Even if it's not a fixed bit rate, it should keep up pretty good and stay there with no problem probably. [spoiler]http://www.ebay.com/itm/SANDISK-EXTREME-PRO-SDHC-95MB-633X-16GB-16G-16-G-GB-SD-HC-UHS-I-CLASS-10-NEW-/320785302234?pt=UK_AudioTVElectronics_PDAsAccessories_MemoryCards&hash=item4ab04b42da[/spoiler]
#5
Tragic Lantern / Re: Tragic Lantern for 6D
January 16, 2013, 05:36:14 PM
Quote from: 1% on January 15, 2013, 04:17:06 PM
It says on the bottom help if you run it.. Its rate X10 so 12 is 120MB/S but this is just the target rate, lowering will cap it but raising it won't necessarily raise it. Really you want to use one of the configs and set up a bit rate that your card can handle. Canon rates aren't fixed and your maximum is max sustained write for the card. 6D uses UHS-1, 5d3 uses faster CF cards. When you set it higher than the card can handle recording stops. Hence you're not having much luck at 3x on your current camera (try a really low ISO it will probably record).

I'll try to speed up dumping rate and see what it does. I guess that is next up. Won't help ALL-I but gop of 3 on IPB should be interesting (or crash).

I've been trying to find an answer, but i can't find it anywhere. At what bitrate does it record without ML with just ALL-I turned on? 
#6
60+ views and not one single reply... :P Is it possible to do?
#7
Feature Requests / GPS-track your stolen camera - 6D
December 28, 2012, 01:41:40 PM
Hi! Would it be possible to use the GPS for tracking the camera? I'm thinking about something like you do with a smartphone if it gets stolen.

Regards :)
#8
General Chat / Re: Magic Lantern Swag?
December 26, 2012, 02:54:17 AM
A snap on camera strap would be great! It could have pockets for batteries/SD cards imbedded into it. Batteries could get a little chunky, but SD card holders in the strap is definitely doable.

Yay or nay for snap on + SD card slots? Frickin yay!