Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - ivosilva

#1
Tragic Lantern / Re: Tragic Lantern for 6D
May 02, 2013, 06:58:50 PM
Quote from: 1% on May 02, 2013, 06:55:42 PM
Yup, just make sure they are UHS 100MHZ and not 208mhz... so those 90MB/s cards are probably out... at least "pro" ones from sandisk.

Ok, thank you!
#2
Tragic Lantern / Re: Tragic Lantern for 6D
May 02, 2013, 06:53:44 PM
Quote from: 1% on May 02, 2013, 06:44:21 PM
2.3 is a bit old... 600D build with RAW is in the YUV thread, has the test.

I got 12MB. It's a Sandisk Ultra, not a Sandisk Extreme. Well, that settles it. I'm going to have to buy some new cards.
#3
Tragic Lantern / Re: Tragic Lantern for 6D
May 02, 2013, 06:40:35 PM
Quote from: 1% on May 02, 2013, 06:33:43 PM
That is like 5MB/s very bad.... I think HDtune test is flawed... run the card benchmark in camera.

I can't find that option on 2.3 on my 600D (haven't installed ML on the 6D yet)
#4
Tragic Lantern / Re: Tragic Lantern for 6D
May 02, 2013, 06:29:57 PM
Quote from: 1% on May 02, 2013, 05:59:16 PM
Do a benchmark and find out it will measure sustained write.  I think these are UHS cards from what I read on google? My patriot card only does like 32-4. I'd like to find a cheap 128gb that will do the whole 50. Its not the sandisk pro.... its optimized for 208mhz and a rip. Hell... even the high 40s would catch us up to somewhere closer to 5d3 writing.

I'm not sure what to think of this gathered info, but a test made in HD Tune returned 5500KB/s. Is this any good?
#5
Tragic Lantern / Re: Tragic Lantern for 6D
May 02, 2013, 05:42:46 PM
Oh well, it's a shame but it's not the end of the world. Guess I'll have to label my cards then  ;D

And what about the cards I mentioned? Are they good to use?
#6
Tragic Lantern / Re: Tragic Lantern for 6D
May 02, 2013, 05:31:19 PM
Quote from: 1% on May 02, 2013, 05:23:28 PM
Focus confirmation had a regression. Fixed.

The unified bin would be too big at this point and the ml config settings don't match. Kind of hard to make the bin to where you won't spend an hour loading it.

And isn't it possible to have each camera model load a different ML version from the card with the right settings? Like a folder for 6D, another for 600D, that way I can use whatever card I pick from my bag. Maybe I'm not the only one doing this?

Also, all my cards are Sandisk Ultra 30Mb/s - will they work fine with higher bitrates and 422 footage?
#7
Tragic Lantern / Re: Tragic Lantern for 6D
May 02, 2013, 01:14:39 PM
Hello everyone,

I have a 6D and a 600D. I have a series of cards that I interchange between them. Until now I used all my cards with bootflag and ML because it works on the 600D and the 6D ignores it.

Now if I install ML on the 6D, what should I do? Should I have cards with ML for 600D and another set of cards for the 6D?