Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - Mauschel84

#1
Hello everyone,

I have a Canon EOS 200D with the issue that it keeps stucking in the firmware update program. Every update (1.0.1, 1.0.3 or 1.1.0) runs up to 99% and ends with this text pushed together:



So I guess it isn't a problem with the update files (SD Cards already changed), but with the update program itself. After un- and replug the battery, it starts the update program again.
Is this a known issue that could solved easily? The support center recomments a replace of the PCB.
With the ROM Dumper I was able to find out the MainFirmware Boot Flag is disabled.



While my search, I've found the topic "Magic Lantern for 200D: Not Dead Yet edition" https://www.magiclantern.fm/forum/index.php?topic=26681.0, where names_are_hard provided the bootflag enabler.
Quote from: names_are_hard on October 27, 2022, 12:06:48 AM
Bootflag enabler: https://a1ex.magiclantern.fm/bleeding-edge/200D/BOOT200D.FIR

My hope is with reseting the FIR boot flag, the camera will start normally.
I've found the addresses of the flags here: https://magiclantern.fandom.com/wiki/Bootflags. The FIR flag is just only 4 Bytes before the BOOT flag.
Therefore my question: Could someone provide somewhat like a "Firmware flag switcher" please?

Otherwise it remains electronic waste.

Best Thanks for your help
Mauschel84