I have been using ML for quite a while today something happened and now my canon is almost dead.
When i turn the camera on nothing shows on the screen.
Here's what i have done:
Portable display test
Im trying to do that but i cant... i compiled the dm-spy-experiments branch and copyed the autoexec.bin when i reboot the camera with this card im getting 3 paused led blinks and 3 fast ones infinitely not sure if im doing somthing wrong here...
I have the ROM0.bin and ROM1.bin from my SDCARD here (link removed).
Please if you can help me i would apreciate very much.
When i turn the camera on nothing shows on the screen.
Here's what i have done:
QuoteSwitch camera Off, remove: battery, card and lens.No good all the same...
Reattach lens, close card slot, reinsert battery and switch camera On again
QuoteRestart camera without any cardStill nothing working...
Quoterename /ML/SETTINGS/MAGIC.CFG to ML/SETTINGS/MAGIC.BAKNop...
restart camera (default settings start-up)
QuoteTry to start up the camera in every dial modeWhen i did that with SD card nothing happpened but without the SD card in CA mode the panel showed up but then dead again just a few sec. on...
QuoteGot a new SDcard formated in PC, used EOSCard to set the bootflag and then copyed ML folder, autoexec.bin and 600D-102.firno good...
QuoteDeleted the files from the card and then copyed new ones i just downloadednop...
Portable display test
QuoteStartup log
You can get a very detailed log about Canon boot process by compiling the dm-spy-experiments branch.
Im trying to do that but i cant... i compiled the dm-spy-experiments branch and copyed the autoexec.bin when i reboot the camera with this card im getting 3 paused led blinks and 3 fast ones infinitely not sure if im doing somthing wrong here...
I have the ROM0.bin and ROM1.bin from my SDCARD here (link removed).
Please if you can help me i would apreciate very much.