Hello,
I have a Canon EOS 60D and tried to install ML, nightly built 29.03.2015. So far so good, the installation was no problem, but I don't understand the instruction or can fiddle out how to use ETTR for photography (I don't use video-mode at all)
Mostly I use mode AV or TV and not live view.
There are several modes for ETTR:
1. Always on - I can't see any improvement in the current shot. It seems to make settings for the next shot (but that's a complete different picture) and so it's wrong
2. Auto Snap - this tries to make a second picture but the camera has been move since...
3. Set or HalfSDblClick should activate LiveView and should go back automatic and take the shot... but it doesn't do so
It would be nice if somebody could explain how ETTR needs to be configured for an automatic single-shot without liveview, with mode (AV, TV, M) in the 60D is supported?
Please excuse my poor english!
Thanks in advance
Pauline
I have a Canon EOS 60D and tried to install ML, nightly built 29.03.2015. So far so good, the installation was no problem, but I don't understand the instruction or can fiddle out how to use ETTR for photography (I don't use video-mode at all)
Mostly I use mode AV or TV and not live view.
There are several modes for ETTR:
1. Always on - I can't see any improvement in the current shot. It seems to make settings for the next shot (but that's a complete different picture) and so it's wrong
2. Auto Snap - this tries to make a second picture but the camera has been move since...
3. Set or HalfSDblClick should activate LiveView and should go back automatic and take the shot... but it doesn't do so
It would be nice if somebody could explain how ETTR needs to be configured for an automatic single-shot without liveview, with mode (AV, TV, M) in the 60D is supported?
Please excuse my poor english!
Thanks in advance
Pauline