I followed a tutorial on installing ML for my Canon 6D, going through all the steps of downgrading to Firmware 1.1.2, formatting the card, back to 1.1.3 firmware with the ML files, etc. After the final step of the process, which seemed to work for most people commenting on the tutorial, I turned on my 6D and saw the following messages at the top of my screen in the following order:
ML/DATA/FONTS.DAT retry
Then it says ML/DATA/FONTS.DAT not found!
At that point, the screen glitches out with colors and I shut off the camera.
I tried looking into the 'Files to Run ML for 1.1.3" folder for the FONTS.DAT file, and adding it to my SD card individually in addition to adding the main folder it was in.
Nothing changed. Does anyone have any advice or insight into this problem?
This is the tutorial I used, and the source for the ML files : https://www.youtube.com/watch?v=dvK_imr-C7M
Thanks!
ML/DATA/FONTS.DAT retry
Then it says ML/DATA/FONTS.DAT not found!
At that point, the screen glitches out with colors and I shut off the camera.
I tried looking into the 'Files to Run ML for 1.1.3" folder for the FONTS.DAT file, and adding it to my SD card individually in addition to adding the main folder it was in.
Nothing changed. Does anyone have any advice or insight into this problem?
This is the tutorial I used, and the source for the ML files : https://www.youtube.com/watch?v=dvK_imr-C7M
Thanks!