Hello!
I just installed ML on my 500D, this is a 4GB card.
Is it possible to just insert another card without ML and just run it like a normal one without ML?
Or do I have to uninstall ML first to be able to use a non-ML card?
I read about it in the installation guide but I didn't understand that part.
EDIT:
I just read this:
"A low level formatted card (used normally) is not bootable.
this is what happen when card is NOT bootable:
1. Bootloader starts up and checks card and boot settings
2. It will find the Boot Flag set so it will check for a bootable card
3. Not found so it will load ONLY canon firmware"
Does this answer my question or is it something else?
I just installed ML on my 500D, this is a 4GB card.
Is it possible to just insert another card without ML and just run it like a normal one without ML?
Or do I have to uninstall ML first to be able to use a non-ML card?
I read about it in the installation guide but I didn't understand that part.
EDIT:
I just read this:
"A low level formatted card (used normally) is not bootable.
this is what happen when card is NOT bootable:
1. Bootloader starts up and checks card and boot settings
2. It will find the Boot Flag set so it will check for a bootable card
3. Not found so it will load ONLY canon firmware"
Does this answer my question or is it something else?