Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Corniger

Pages: [1]
1
Tutorials and Creative Uses / Focus stacking on the 7D - tutorial
« on: December 31, 2018, 06:07:12 PM »
Since I found all videos on YT very misleading, as recorded using 5D models, and I just found one halfway botched entry on using it on a 60D with way too many unnecessary things in it, I thought I'd post my own, so I can remember it better.

It SOUNDS complicated, but in fact it's just always "pushing the DEL button" in between that makes the instructions look lengthy, but that's necessary, otherwise you won't get the visual information required to complete this operation.

  • Power on cam
  • activate Live View
  • press DEL twice to activate ML
  • go to camera settings tab, activate "Global Draw, on, all modes" and then activate "Focus peaking", color set to something contrasting with the subject (only needs to be done once for setup, only works with focus loupe disabled!)
  • go to focus settings tab, set "Follow Focus" to "Arrows" (only needs to be done once for setup)
  • press DEL deactivate ML menu
  • manually focus (or push the joystick left) on the point farthest away the camera should focus on. I you can't see focus peaking lines and dots, you have native Canon menus activated. Press the "Info" button repeatedly until you get to a screen that only shows the ML level bars and info. You'll then see focused details highlit in the color you chose in step 4
  • press DEL activate ML menu
  • go to "Focus" Tab (1 to the right)
  • select "Focus End point" and press "Q", top left button. The Focus End point is now greyed out and set to "0, here". ML knows where to start from now.
  • press DEL deactivate ML menu so you can see the peaking!
  • press the joystick right to get the motor into motion, focusing closer towards you. ML now counts how many stepas the motor has to complete to go to where you want it to. Once the peaking is visible to the closest point that should be in focus, press DEL
  • back in ML, you select "Focus stacking", select "copy rack range" and "start focus stack". Setting the correct number of steps etc. is individual and depends on what lens you use. Every time you alter the number of steps, you have to copy rack range again!

Edits: after extensive use, I found out some steps I previously described could be skipped.

2
General Help Q&A / "Focus Stack not completed" Error
« on: December 31, 2018, 05:40:58 PM »
Hey there,

I've been shooting macros using ML's focus stacking function for a couple of days now, everything was working fine, now suddenly on a specific subject one single shot is taken, then the cam beeps and ML notifies me the stack wasn't completed. I already tried restarting the camera, to no avail. I've reset the stacking procedure 10 times, always the same result.

Does that error ring a bell? Couldn't find any info except in the ML code online.
Please help, it's critical I get this done, stupid timing on New Year's eve.


Thanks :-)

Pages: [1]