Messages

1

General Help Q&A / Re: Canon m50 compatibile?

« on: June 19, 2020, 01:15:18 PM »

I'm also wondering the same. my nephew has the M50 and was impressed with what my old M can do with ML installed

2

Shoot Preparation / Re: intervalometer stopping before all shots were taken

« on: June 18, 2020, 07:24:56 PM »

so wanted to report back on the subject.
I don't know why, but if I set the camera to Bulb mode and shoot 1min long exposures, everything is fine. If I set it up to shoot at the camera's max shutter speed (30") then it stops shooting even if it didn't reach the amount of frames I set it up to shoot.

either way I find that for star trails, 1 min frames works better - less ISO noise, but not too long long of an exposure to show sensor noise or that purple stains in the edges of the frame.




 

3

Shoot Preparation / Re: intervalometer stopping before all shots were taken

« on: May 22, 2020, 05:47:24 PM »

Thanks. Noise reduction is off, and the camera takes shot after shot perfectly with only 1sec between images, but it just stops after a while, and before it hits the amount of shots i  set for it

4

Shoot Preparation / intervalometer stopping before all shots were taken

« on: May 22, 2020, 04:47:48 PM »

with covid19 put a hold on all my plans for night photography for the past couple of months, I'm about to head out to try some today, but for the life of me I can't understand why would my camera stop taking pictures before the amount I set for it.

for ex,  I set it to stop after 120 shots of 30sec, but I only got 90 pic or so..
 
Camera is connected to a powerbank (still full), and camera power saving modes is set to "disabled" so neither the camera or the power bank are going into sleep mode

more info-
intervalometer setting:

Take a pic every - "shoot like crazy" (so I don't have big gaps in the star trails
Start trigger - "Leave manu"
Start After - 10s
Stop after - 120 shots
Camera setting:
Shooting drive =continuous shooting
Image review = off

don't know if anything else I'm doing might be the cause of this?

Thank in advance!

5

Shoot Preparation / Re: Total newbie to ML - seeking advice for star trail stills photography

« on: February 25, 2020, 07:57:37 PM »

Thank you all! some very interesting idea on here i'll need to try out.

Sorry for the late reply, the "notify me of replies" option didn't work...

Cheers !

6

Shoot Preparation / Total newbie to ML - seeking advice for star trail stills photography

« on: February 19, 2020, 10:18:00 AM »

Hi Guys.

I have a trip to the Canyonlands NP coming up next month, and was thinking of taking my EOS-M along side my A7iii. was hoping to use the EOS-M as a B camera to capture mainly stratrails (connected to a Powerbank), while the sony does most of the heavy lifting for the milky way. I'm not new to photography, but ML is kinda new to me.

I do my startrails, by exposing multiple images , at around 30 sec each, and stacking them afterwards in PS. I use the histogram and try and have it go all the way to a bout the middle point, so I still get some color in the stars

I started playing around with ML (June 2018 build if I'm not mistaken), but found most videos on youtube are for video mostly, and the amount of info, along with the differnte builds got me a bit confused, so I'd appreciate any advice regarding setup, things to look for, or ideas for when I go out to shoot.


a few questions to get the ball rolling if you don't mind:

1) what's the best practice (setting wise) to be able to zoom at night on the stars?

2) Any suggestions (ML setting wise) for the actual shoot?

3) From your experience with the EOS-M, any recommendations of do and don'ts for such shots (like max ISO etc) ? nights will be cold if it makes any difference.

4) intervalometer: - how to I stop it once it started (without taking out the battery) ? is there a way to set it to where the there's absolutely no gap between pictures taken (not even 1 sec)

5) I enabled the "Global Draw" and really like the fact I can see the focusing distance , but is there a way to control the camera settings, or the X10 zoom while at that window? Iat the moment I need to switch to 1 of the regular displays by hitting the INFO button

6) I was reading some on Dual ISO and ETTR, but is seems like it is not something I should use for long exposures, am I correct?

any other advice?

Thanks a lot for your time.


Pic from a trip 5 years ago, before I knew ML or stacking was even a thing. so 30 min at ISO 200, with another 30min of in camera noise reduction.