Messages

Hey men ! I can't believe you registered just to answer me ! That's so kind of you, thank you

Unfortunately, I tried this manipulation but I can't access to the menu, in any mode. The camera always print Err 70 :/

Hey there !

Still no solution for me 

Do you have some time this week or the next one a1ex ?

Thank youuuu

Hello guys,
Sorry for answerring lately, i've been sick for a while 

If the camera is recognized by the PC via USB, I can give it a try. You will need to give me some kind of remote access to your computer. Timing is not right, but I expect some reduced workload in 1-2 weeks, so... please remind me if you don't find a solution meanwhile.

The camera is recognized by the PC, we can have a try with teamviewer whenever you are available

Otherwise, you will need some electronics skills to connect a UART dongle to the camera (you don't have to disassemble it, as it's under the rubber cover). There, you will see the exact error message from Canon (not just the code). I can assist you with that as well.

I think I can do that if it's necessary.

If the camera already has ML installed, you could run the portable ROM dumper or other diagnostic tools directly from the SD card (no wires or cables needed in this case).

I'm almost sure it's not. Is there some kind of tuto somewhere to install it ? I can do it if it's helpful.

Thanks to both of you for your help

Do you know what Magic Lantern is?

I just looked up on Google, is it some kind of firmware to make movies with your camera ?
So I imagine this forum is dedicated to camera wich runs ML ?.. I feel stupid, I was thinking that it it's a place where people helping each other with their camera... ^^
Sorry for bothering ! Do you know a forum where I can find some help for my issue ?

I don't think so, however i'm not sure about what ML is... 

Hello everyone,

My Canon EOS 60D doesn't boot anymore. When I turn it on, I got an Err 70 displaying on the screen.

I've been reading some threads about that, looks like it's a quite common issue, but I a complete noob and I don't understand well the procedure to unbrick it.

If someone can help that would be awesome

Thanks, have a nice day !