Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Robo18

#1
General Help Q&A / Re: Installation of ML on T3i
December 10, 2018, 05:38:24 PM
Yes and the nightly build folder is part of the unzip. I get it, you're tired of asking if the computer is plugged in.
#2
General Help Q&A / Re: Installation of ML on T3i
December 10, 2018, 05:22:59 PM
That'll help. You'll want to make sure they (me) don't just copy the nightly build folder over as it wouldn't satisfy the root directory requirement. Us newbs are a literal bunch!
#3
General Help Q&A / Re: Installation of ML on T3i
December 10, 2018, 05:07:51 PM
Thanks Walter and dfort!

Putting the the 3 files in the root directory, naked as it were, did the trick. Being a non-programmer and a newb to ML (and a Nikon shooter to boot) I didn't realize I needed to delete the DCIM and MISC files after formatting in the camera. Thanks for taking time to help me.
#4
General Help Q&A / Re: Installation of ML on T3i
December 10, 2018, 04:13:15 PM
Thanks for getting back to me Walter.

I checked the unzipped file and it did contain the ML-SETUP.FIR file. I tried two different cards in case there was an issue: both are Sandisk Extreme Pro 16GB SDHC I Class 10 (one is U1 the other is U3).

I'd be interested in how to partition the SD card in a fashion that would trigger a firmware update. Don't know if it matters, but I'm running Mac Mojave.

Appreciate your help!
#5
General Help Q&A / Installation of ML on T3i
December 09, 2018, 08:34:19 PM
I just purchased a T3i hoping to install ML. I successfully upgraded the Canon firmware to 1.0.2. I formatted the card in camera and installed the unzipped 2018-7-3 nightly build in the SD card's root directory. The message I get consistently is that the card contains no firmware updates. Is there something I'm missing? Appreciate any help you can give me.