Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ruc

Pages: [1]
1
General Help Q&A / Re: RAW files on IPAD / Crop Mode 5D M3
« on: November 21, 2018, 08:01:19 PM »
is that not for recording more than 30 minutes?
And the problem is the stopping not the starting ;)

2
General Help Q&A / Re: RAW files on IPAD / Crop Mode 5D M3
« on: November 19, 2018, 08:09:01 PM »
Hallo. I tested now without the raw module.
No problems.

But when I load the raw module the record don’t stops.

With the other version there was no problems.

3
General Help Q&A / Re: RAW files on IPAD / Crop Mode 5D M3
« on: November 15, 2018, 09:35:56 AM »
Ok thanks. Crop mode is perfect.

Now I have another problem. Many times I get now the error 70 and have to shut down the camera.

For work it is very dangerous when a clip is not recorded.
What can be the reason?
Also RAW recording problems. It starts to record but it doesn't stop. There is standing stopping, but nothing happens. The card is a new komputerbay 1066x 128GB CF card.magic lantern runs over sd card.

4
General Help Q&A / RAW files on IPAD / Crop Mode 5D M3
« on: November 08, 2018, 11:31:46 PM »
Hello,

I need to work sometimes with the crop mode, because of the zooming :) I have a 5D M3 and tried already to record with the crop mode and raw.

Is it possible, that I record into H264, so I can handle the file? I guess no...

Or is it possible to convert the files on an IPAD, so I can use the files than in video editing programs on an IPAD.

I need a workflow for run&gun, so I don't have the time to open after effects, camera raw and so on. It has to be on the iPad.

Or what can I else do to work with a crop mode?

thx

5
Camera-specific discussion / Re: Canon 5D Mark III / 5D3 / Firmware 1.3.4
« on: November 07, 2018, 10:29:28 AM »
Hallo,
is there any new news if magic lantern functions with 1.3.4 or 1.3.5?

I managed to make it work some time ago. But the card is gone and I do not have a card that is "bootflag" and I do not know how to do that either.
So I'm considering whether I go to firmware 1.2.3 and magic lantern run let.
Is there any pros or cons?

6
Hallo friends,
I read first after that the ML-SETUP.FIR is not there. Where can i get it? So i can upload it to the card??
I have now just the 1.3.4 and no magic lantern.
Please Help.

Pages: [1]