Messages

Are there any updates ?

No offense was intended and no inference made about A1ex skills or honestly i wouldn't be asking on the forum , i dont know where that came from , about asking for the firmware , just want to cross my t's and dot my i's before i give up on the cam , been given the run around earlier by canon for a out of warranty cam , finally had to get it fixed locally

would anyone be able to send me a stock firmware so i can confirm its a hardware issue before i write it off and send it to ebay for parts , the thing is it was working fine before the bad load of magic lantern , i have used lantern before on my 600d and 7d,never faced anything so drastic , cams out of warranty and from what i read online canon will suggest a main board replacement

is there any chance anyone has the stock firmware to reflash so i can get it back to stock and use it , currently its a expensive paperweight

Any Instructions for me ?

loaned my cam out and it came back with a error 70 after a magic lantern install , guessed i should reload magic lantern to troubleshoot it as i cant seem to find a stock canon 70d firmware anywhere , guess whatever image setting was changed was recorded in the nvram , i have cleared settings in all modes both through the canon menu and in magic lantern , no luck till now

canon 70d , getting error 70 & error 80 ,
shows memory error - underflow
Sub menu shows -

allocated ram - 684kb, peak 684kb - values change
malloc -227kb,77kb used
allocate memory 1.9mb,506kb used
shoot_malloc - 32mb,101kb used - values change
stack space - 525kb - values change
shoot contig 0
shoot total 0
srm job total 0x0
autoexec.bin 449kb of 640kb


image buffers -720x480,720x480
internal temp - 166 raw - help need

after some time , sd card light will turn on and camera will freeze , will have to remove battery , turn off and on couple of times , sometimes camera screen will turn on most times it stays black