1
Camera-specific Development / Re: Canon 6D / Firmware 1.1.6
« on: June 30, 2015, 05:55:55 AM »
It did that before ML installed in both 1.1.3 and 1.1.6. Again, no big deal.
News:
Etiquette, expectations, entitlement...
@autoexec_bin | #magiclantern | Discord | Reddit | Server issues
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Camera-specific Development / Re: Canon 6D / Firmware 1.1.6
« on: June 27, 2015, 09:21:24 PM »
Yes, I agree. I choose yes/continue and the camera works just fine. I would just be wary of the percentage left. I use the Canon batteries first then keep the other two for "just in case" scenarios.
3
Camera-specific Development / Re: Canon 6D / Firmware 1.1.6
« on: June 27, 2015, 07:36:26 AM »
I tried using 2 different after market batteries, one I don't even know the manufacturer, the other is a Wasabi . . . neither one of them are recognized and each gives me a different message when I power up:
Unknown - "Cannot communicate with battery, Use this battery?"
Wasabi - "Communication with Canon LP-E6/LP-E6N battery is irregular. Continue to use this battery?"
They power the camera if I choose to continue but I'm not sure how correct the battery percentages are. I'll stick with the original OEM Canon batteries just to be safe.
Unknown - "Cannot communicate with battery, Use this battery?"
Wasabi - "Communication with Canon LP-E6/LP-E6N battery is irregular. Continue to use this battery?"
They power the camera if I choose to continue but I'm not sure how correct the battery percentages are. I'll stick with the original OEM Canon batteries just to be safe.
Pages: [1]