Thank you Levas.
The following 3 lines do confuse me though:
Make sure you are running the right Canon firmware version, specified on the download page
You can check your firmware version by setting your mode dial to Manual (M) and looking in the Canon menu.
Nothing bad will happen if you try to run ML on a different firmware version - the card LED will start blinking and you'll have to take the battery out. Magic Lantern checks firmware version before attempting to run.
Does that mean I have to change my camera Firmware version from 1.1.6 backwards to 1.1.3 for it to install? Or is it simply telling me that with 1.1.6, when the LED starts blinking, I remove the battery, put it back, and the install will occur?
Thank you.
Adge
The following 3 lines do confuse me though:
Make sure you are running the right Canon firmware version, specified on the download page
You can check your firmware version by setting your mode dial to Manual (M) and looking in the Canon menu.
Nothing bad will happen if you try to run ML on a different firmware version - the card LED will start blinking and you'll have to take the battery out. Magic Lantern checks firmware version before attempting to run.
Does that mean I have to change my camera Firmware version from 1.1.6 backwards to 1.1.3 for it to install? Or is it simply telling me that with 1.1.6, when the LED starts blinking, I remove the battery, put it back, and the install will occur?
Thank you.
Adge