Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - power1001

#1
yes I tried on several cards
#2
I tried resetting to default settings, cleared CFN setting, and to ML default a couple of times.  Did not correct.  I don't get any error warnings.  It just hangs at please restart your camera with continuous flashing until I remove battery.  It then starts normally.  I tried a bunch of times, counting count down to 5 sec, etc and it continues to repeat. 
#3
@nikfreak
Interestingly, if I reload magiclantern-Nightly.2016Apr20.100D.100B, it works fine and I can restart with on/off switch.  When I then reload magiclantern_Nightly.2016May01.100D100B it hangs again at reload and I need to pull battery.  ML works fine after that.
#4
@nikfreak
the support/install guide page TROUBLESHOOTING sections says:
Troubleshooting
If the card LED blinks continuously after running Firmware Upgrade, you don't have the right Canon firmware version or sub-version. To fix it, install the official Canon firmware upgrade from the links found on ML download page, even if you already have the correct version number (you may have a different sub-version number).

A new card didn't help.  I'll try some more reloads.
#5
@nikfreak - thanks and great work... in the last three builds, after I install ML I get the continuous flashing and camera will not shut off until I remove battery.  After that, ML seems to work fine.  When I update, I first remove ML, and then format card, and then load new build.  I read that this means I don't have correct firmware.  However, I only started to have this problem in the last three builds.  Should I reload firmware ?

magiclantern-Nightly.2016May01.100D100B