Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - jucau

Pages: [1]
Archived porting threads / Re: Canon 6D
« on: September 25, 2014, 11:22:29 AM »
@ Walter_schulz : sorry if i was not clear. Yes, i was using my macbook internal cardreader and it didn't work, i couldn't write on the card, just read it. After looking on internet to find a solution, i tried several times to plug the card in my mb cardreader as explained (strange solution, but anyway...), and it finally worked ! so i could put the firmware file on the card, and now it's all ok. ML is uninstalled, after following the simple procedure explained on the first page.

Macbook internal cardreader is just hazardous.

Thank you for your help !


Archived porting threads / Re: Canon 6D
« on: September 24, 2014, 12:27:43 PM »
@ walter_schulz : i already have a cardreader on my macbook, but i'm not allowed to write on the card when it's plugged, just read. And more surprising, i can't even format it from disk utility. Maybe a software can pass through this restriction or allow me to write on the card ?

Anyway, do you think the problem is what i think : i don't have the "ML-6D113.FIR" file on the card ?

Archived porting threads / Re: Canon 6D
« on: September 24, 2014, 11:51:10 AM »
@ Levas : i think i understand now what is my problem. I probably did a mistake when i installed ML, i didn't paste the "ML-6D113.FIR" file on my memory card. Maybe i should. So probably I can't run the update if i don't have this file on the card. The problem is, from my computer (mac) i can't write anything on the card, i can only read it. So i can't copy/paste the "ML-6D113.FIR" file to repair my mistake... is there a solution for that ? format everything from the camera (even ML) and restart the procedure ? format from my mac (i can't actually, the "format" button is in grey, so i don't know how) ?

Thank you !

Archived porting threads / Re: Canon 6D
« on: September 24, 2014, 01:13:11 AM »

first thank you for this great software !

I'm sorry but i have just a question : I don't know how to uninstall MagicLantern. I know i may not be the first one to ask that (i'm french and my english is not good enough to read all the forum to find the solution, i've seen something close on the previous page but it's not exactly the same uninstalling problem)

On the first page it's written "1) Run Firmware Update from your ML card. 2) Follow the instructions."

If i go to the "Firmware ver. 1.1.3" menu, it just say that a memory card with firmware is necessary for update, nothing else.

I have the "Built on 2014-05-01" version of ML, maybe it's not the same process ?

Thank you for your answer :)

Pages: [1]