Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - chopper2585

#1
Quote from: goran on June 24, 2014, 08:25:52 AM
Please report if the problem persists with the new card.
BTW I've had a couple of Lexar UDMA 7 card readers go crazy and corrupting files during transfer. Transferring the same files from the same card with a different reader didn't show any problems and the files were ok, so I'd check also a different reader just to be sure.

All best,
Goran



Thanks for the heads up on those. I'll keep an eye on my reader in case that happens to any of my files.

I got the new card in today and everything works great, no more lines or issues, and the card is much faster. I can record continuously at 1920x1152 at 23.986.

Thanks for the help!
#2
Quote from: goran on June 23, 2014, 08:06:27 PM
From my experience, and I may be completely wrong, this happens before the card is about to get corrupt. The only time I encountered something like this was after Komputerbay 64gb card was used with non UDMA 7 card reader which apparently corrupted it and after that I experienced something like this. Just my 2 cents.


Thanks, I went out today and took a lot of stills, finding a handful were corrupted. I'm thinking (hoping) that it is in fact the card. I have a Lexar UDMA 7 card reader, but the card might have been bad from the start. I have a new one coming Wednesday so I can test the SanDisk Extreme this time.



Quote from: a1ex on June 23, 2014, 06:59:10 AM
Can you share your config file, the steps to reproduce, and how often you get the issue?

Does it happen with RAW, MLV or both?

External monitor or built-in LCD?

Other Canon settings?

A screenshot of Debug->Show EDMAC, without any modules loaded, in movie mode, should be also helpful.

After getting some corrupted stills, I ordered a new card. Though it was benchmarking okay, maybe the card is going bad. I'll send you all the details if I still experience the issue on the new SanDisk I ordered. Thanks for the reply!
#3
Quote from: goran on June 23, 2014, 06:24:35 AM
Which card do you use?


I'm using a Komputer Bay 64gb 1000x. I'm noticing it at all resolutions.
#4
Hello, I just installed ML on my mark iii, and I'm getting two horizontal lines of dots across the frame. It pops up for one frame then goes away, then might pop up a few seconds later on another part of the frame. It's always only for 1 frame, and the timing in between is random.

Here are 3 frame shots from the clip showing the lines. Has anyone seen this before?