Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - PeterTosh

#1
Quote from: bandgap on April 27, 2014, 11:48:48 AM
Hello everyone!
I am new with ML and I can't install it. I donwloaded the latest nightly build, copied all the files of the archive to the SD card as it written in the manual on the first page. ML says it was installed, bootflag was also installed, and then the program asked to reboot the camera. I switched off it, took out the battery and inserted again and switched the camera again. But nothing happened, Canon stock firmware is still there. I tried to flash the camera with the original firmware available from the first page of thes thread, but nithing helped.

Could someone help me please to figure out what I've done wrong?
PS. The camera was bought in Germany in December 2013, if this relevant.

What version of the firmware do you have installed?
#2
Quote from: dmilligan on April 23, 2014, 04:14:23 PM
In scenes with a lot of motion/detail H.264 can look like terrible. Even a lower resolution RAW footage may outperform the H.264 at a higher resolution in terms of detail preservation, same would go for motion artifacts. Additionally, having the extra dynamic range and color depth, may be more valuable than simply having higher resolution.

Makes sense - thanks!
#3
I have the latest nightly on my new 6D. It works fine in general - thanks to everyone for all of their hard work!

One specific question about RAW video recording... 1792x resolution is the largest I can select, but it says that it requires like 80MB/sec to do 29fps at that resolution, and the max my card (and the 6D in general?) can do is 40MB/sec or so. To get down to 40MB/sec I have to lower the resolution way down - so what's the point of recording in RAW at such a low resolution? Am I missing something here?