Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - mdbatter

#1
Quote from: mdbatter on Yesterday at 11:42:38 PM

    Well done to all the developers of MLRawViewer!

    Now I'm may be about to ask a silly question!  I have been happily using v1.1.6, but decided the other day to update to v 1.2.3.  But when I unzipped the file (I'm running win7), nothing would work.  The exe file does not run, nor if I drop an MLV file on it does anything happen. And no LOG file is produced in my User directory.  On further investigation, v1.1.7 will work, but not 1.2.0 or anything later (where there has obviously been a change since there were only 3 files in the zip folder up to v1.1.7, but 878 files for all later versions).  Am I doing something incredibly stupid?

    Thanks.


It should have created a ".mlrawviewer" dir in your /Users/<username> folder. The log file is in there. After checking it, try deleting the whole dir and running again.


Baldand - thanks, but as I noted in my first post, there was no LOG file as there was no ".mlrawviewer" folder created.  Perhaps not surprising as the program did not appear to run at all. I have now tried on a win7 laptop with the same results: v1.1.7 works fine but 1.2.3 does not.  However, the laptop did create a ".mlrawviewer" folder but that did not contain a LOG file but it did contain three files named: "encodeType", "loopPlayback" and "updateVersion".  The latter just had "1.1.7" in it. the other two a couple of symbols only.

I assume I do not need to install Python separately on a win7 machine?  Otherwise, I am at my wits end as no-one else seems to have reported these problems.
#2
Well done to all the developers of MLRawViewer! 

Now I'm may be about to ask a silly question!  I have been happily using v1.1.6, but decided the other day to update to v 1.2.3.  But when I unzipped the file (I'm running win7), nothing would work.  The exe file does not run, nor if I drop an MLV file on it does anything happen. And no LOG file is produced in my User directory.  On further investigation, v1.1.7 will work, but not 1.2.0 or anything later (where there has obviously been a change since there were only 3 files in the zip folder up to v1.1.7, but 878 files for all later versions).  Am I doing something incredibly stupid?

Thanks.