To asnwer my own question. I had to download a different version of CR2HDR, then the checkboxes appeared 
- Welcome to Magic Lantern Forum.
News:
Etiquette, expectations, entitlement...
@autoexec_bin | #magiclantern | Discord | Reddit | Server issues
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
HDR and Dual ISO Postprocessing / Re: BarracudaGUI for cr2hdr dual iso raw post-processing (Windows XP/7/8)
July 28, 2014, 12:53:14 AM #2
HDR and Dual ISO Postprocessing / Re: BarracudaGUI for cr2hdr dual iso raw post-processing (Windows XP/7/8)
July 27, 2014, 04:10:49 PM
OK, I am lost. I know the parametrs boxes are generated dynamically, but I don't see any checkboxes now. I use the build listed in the 1st post of cr2hdr thread.
Any help?
Any help?
#3
Tragic Lantern / Re: HOW TO: A guide to installing ML on the 7D with recent features
October 19, 2013, 02:09:43 PM
Guys, I need your help.
Followed all steps very carefully. I had previously installed ML to 5Dm3 with not problems.
Now, after I updated my 7D witch patched .fir, the led turned RED, stayed for about 15s, then the camera looked as if it was completely off.
Waited couple of minutes - nothing. Turned it to off position, then back to ON, nothing happens.
As if the battery was dead. Completly no reaction...
Is there anything I can do?
Followed all steps very carefully. I had previously installed ML to 5Dm3 with not problems.
Now, after I updated my 7D witch patched .fir, the led turned RED, stayed for about 15s, then the camera looked as if it was completely off.
Waited couple of minutes - nothing. Turned it to off position, then back to ON, nothing happens.
As if the battery was dead. Completly no reaction...
Is there anything I can do?
Pages1