Messages

So, I have noticed that the display flickers between the hi/lo ISO's. It states that there will be some flickering while recording. I Don't mind that. Is there anything that I have to do regarding the playback to stop that flickering? Do I need to record in 24fps and playback in 30fps? I have searched but not really found anything of use.

Anyone have any suggestions or fixes?
Any help would be appreciated. Thank you in advance.

This is just a super short five second film showing 24fps vs 30fps really for my benefit as I have never made a time lapse video before. I used time lapse assembler (a free mac program) to compile the two videos and fcp x to overlay one on top of the other. I shot at one second intervals shooting just 100 shots (had to meet my daughters doctor) so I shot this in the parking lot just before going inside to meet him.

The 30fps video for all intensive purposes runs out at four seconds as you most likely have already deduced.

Of course I believe that it goes without saying that I used ML and it honestly could not have been easier. I installed it last night to my SD card and my goodness this firmware is fantastic.