Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jtkleine

Pages: [1]
1
Raw Video Postprocessing / Re: The CinemaDNG Discussion
« on: June 04, 2013, 01:39:42 AM »
@chmee, I'm shooting with 550D. I suppose it's a 14bit body.

Here's a link to a raw file:
http://kleine.me/clients/mlraw/M04-0102.RAW

Screenshots from Resove & Speedgrade:



2
Raw Video Postprocessing / Re: The CinemaDNG Discussion
« on: June 03, 2013, 11:40:31 PM »
OK, I shoot a small clip and upload the raw file a little later. Where should I upload it? Maybe I just put in on a server and link it here. A screen shot too. But I don't have time today to fiddle with the black level settings in raw2cdng, so I just use the default.

3
Raw Video Postprocessing / Re: The CinemaDNG Discussion
« on: June 03, 2013, 10:53:03 PM »
Just wanted to chime in, that I managed to open a file originating from 550D in Resolve. I did run raw2cdng under Parallels in OS X Lion, in 16bit mode of course. The file looked basically OK, but it was just something I shot in a minute. I couldn't do any actual testing, as the clip had horrific noise and no real black or white to begin with. Just wanted to see if it works at all. Sorry, I have not time to do anything more helpful right now.

BTW, I tried also in Speedgrade, just for fun. That didn't work at all (I didn't expect it to). The image was mostly green. I don't think Speedgrade even supports CDNG, maybe only Alexa and R3D.

Chmee you are doing as a big favor. No much point in grading raw video footage anywhere else than in Resolve -- at the moment at least. I tested earlier some clips in AE and graded them wit Color Finesse. That workflow didn't make much sense. I mean, to first bake the raw data into static rgb and then start grading. Very frustrating. So thanks, great stuff.

4
Raw Video / Re: 550D raw video recording port official thread
« on: May 27, 2013, 07:41:15 PM »
Sorry if this is a stupid question, but I don't seem to be able to figure this out by myself. The resolutions that we are using with 550D -- are they 1:1 crops, or are they scaled down from some larger area of the sensor? I think I would prefer a 1:1 crop. I know the sensor has a bayer pattern, but still.

Pages: [1]