Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - gipukan

#1
Camera-specific Development / Re: Canon 5D Mark IV
October 14, 2019, 05:48:22 PM
#2
Camera-specific Development / Re: Canon 5D Mark IV
October 06, 2019, 01:42:32 PM
Got some files generated  in my 5d4. LV.RAW, DEBUGMSG.LOG and DEBUGMSV.LOG where do i put them? Stangely is that they showed up om my SD card and not my CF card.
#3
Camera-specific Development / Re: Canon 5D Mark IV
August 29, 2019, 05:12:04 PM
Great, Got my 5d4 on 1.0.4 and ready to run some tests if still needed Alex.

Saw some progress already and I tried som fir's but could not get a lot of data. Got the boofflag fir downloaded but not yet implemented.

ML still runs fine on my 7d :)

Gip
#4
Ok saw it thx Alex
#5
Hey Alex,

Got a no go for my 7d on motion detect w/o live view on :( Switching live view on works like a charm but not without.
#6
Nice, can confirm now that the jpg's and mov's i made are still there :) Tomorrow a new ML testday :)
#7
Getting my shots of the 7d's cf card now, saw some jpg's and mov's that the 7d preview did not show while in ml. Gone try to reproduce that and report
#8
Ok will give hat a try tomorow! Now i have to see if ML did not delete some shots I made in the morning before using ML.
#9
Hi, I'm using ML alpha 2 in Motions sensor more in live view. 2 things I want to mention besides thanks a lot and will soon donate!

1, Can motion detect also run in non live view more please? and 2 in does drain my battery fast but i still wonder if that's not an issue normally when in live view. I'm hoping to convince my photo club members to start using ML on their 5D's and 7D's when i'll give them a demo :) during a club session!
#10
General Help Q&A / Re: Using intervalometer on 7D?
April 17, 2013, 11:32:17 PM
Funny, by putting my other cf card in the 7d intervalometer started working again....
#11
General Help Q&A / Re: Using intervalometer on 7D?
April 17, 2013, 10:19:36 PM
For some reason the intervalometer in counting down now but is not taking a pciture on my 7d with aplha2 installed. Yesterday it worked fine.
#12
Gee thanks ML for the alpha2, Been looking for this a long time now after running alpha1 w/o a hitch!

Installed it today and so far so good but one small think i think.

When using intervalometer in conjunction with timelapseramping set at sunset a square is displayed on my screen that flickrs a few times during calibrating and end with the message intervalometer had stopped after telling me it can not calibrate.