Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - vertigo235

Pages: [1]
1
Modules Development / Re: DotTune AFMA (dot_tune.mo)
« on: March 17, 2016, 03:40:02 PM »
Found an issue using 1.2.3 and the DotTune module on 5D3.

I found it working fine on prime lenses, but on my zoom lenses DotTune would scan all the ranges and would never find a boundry (like described above).  I tried the prime/tele both, and the applicable wide / tele settings and got the same result.

I assumed that ML was having trouble adjusting the values, so I switched to "All by same amount" mode, and this worked fine.   So it appears when a zoom lens is attached ML can only adjust the AFMA on the "All by same amount" mode.

Anyhow, so the easy workaround is to do the DotTune with this mode then manually change the values for the Tele and Wide once the values are calculated.

2
FWIW I was able to downgrade to 1.2.3 on my new 5DIII using canon utility 3.x, I didn't have to use 2.x as stated above.

3
Camera-specific discussion / Re: Canon 6D / Firmware 1.1.6
« on: September 06, 2015, 02:58:58 AM »
Awesome I'm excited to update to 1.1.6. Good work!

Pages: [1]