Purchased an M2 marked as defunct and it came as defunct! Surprise!
Press ON/OFF and after very short time green LED begins to blink fast. And doesn't stop (tested for several minutes). Pressing ON/OFF again will stop it.
Pressing Play button at startup does *not* startup camera. But opening battery compartment, pressing Play (and keeping it pressed) and closing compartment door will startup cam with blinking LED. Can be shutdown by pressing ON/OFF, too.
If procedure is repeated without battery pull cam will not startup.
I tried with/without card. I tried cards prepared for ML. With/without Portable Display Test autoexec.bin and with cards prepared for other cam types. No reaction so I assume cam's bootflag is not set.
I suppose there may be a slight chance to get some diagnostics by accessing cam's UART and that's all I can do. Right?
Please provide us with updates if there are any. :)
Got mail from connector distributor: Delivery estimated in 3 weeks.
Web site says 10 weeks.
EDIT:
I have an micro-SD adapter able to provoke the same LED blinking with my EOS M. If inserted into 650D cam will just not start.
This adapter once got some rubber/leather glue attached to contact pads and hasn't got a proper cleaning.
Could it be? Just a mere contact problem? Sounds too easy!
... and probably is. Error exists without card inserted ... sigh!
Hello Walter,
did you have any updates about your EOS M2 ?
I actually have the same issue. It happend after the camera was dropped on the floor more than a year ago...
I was hoping to make the camera work again.
Dou you still have a functionnal ML build for the EOS M2 ?
I have a M10, which was permanently blinking at startup. The reason was a stuck shutter blade.