Hello, i have lastest nightly build 1.2.3 on 5D Mark III camera.
While i shooting raw on my CF card i cant control my Shutter and Aperture wheels - when i move it - nothing happens.
What am I doing wrong? Thanx
Are you sure you are in M mode on your Canon?
I am in M mode on 1.1.3 5D3 and have the same issue as tayz0n. I can use ETTR one time during recording (both RAW and MLV). magiclantern-Nightly.2015Nov07.5D3113
Does it help if you disable extra hacks?
No, it does not (extra hacks for MLV and small hacks for RAW)
Just tested with raw_rec on 5D3 1.1.3. The behavior is not consistent - there are times where I could change both shutter and ISO without issues, and there are times where shutter can't be changed, regardless of small hacks status. Go figure...
SanDisk Extreme Pro 256GB 160MB/s 1067x. Canon 5Dmark3 1.1.3
1920x1080 continue writing MLV with sound - on and GlobalDraw - on. 46,8 min recording full card.
"Busy" is flashing on small upper display from 0 until 9min.45sec. and impossible to change Av or Tv. After this time (9min.45sec) "Busy" disappear and it is possible to change Av and Tv. But if you press autofocus button - "Busy" is flashing again.
I can change shutter speed and aperture while recording MLV (RAW 2.0) on my 5D3 firmware 1.2.3 with nightly build from august 2014
Consistent behavior? (in other words, can you reproduce it for 20 recordings in a row?)
Can't change the iso through canon menu, and if I do try change it through magic lantern while recording in MLV (RAW 2.0) camera crashes.
BUT I can change Shutter speed and Aperture while recording MLV (RAW 2.0) all the time . (just did 25 recording test, all worked fine apart for changing the ISO, but I would suppose it is pretty normal not being able to change ISO while recording.. the way I see it it's like changing the film of your camera you are shooting on it)