Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - jarbi

#1
Camera-specific Development / Re: Canon 1200D
March 24, 2017, 08:51:38 AM
Hi a1ex,

I'm sorry for the confusion, now I made sure I'm using your installer. Before installation I have disabled the boot flag on my SD card, and the installation was flawless this time !! But Murphy was also "present": the video I have recorded is somehow corrupt. Nevertheless I can post some screenshots from it: https://drive.google.com/open?id=0B5rc5Ssg9hE-c0JucnZCMlZFUUk

So your new installer works fine as I see, thanks again,

Cheers,

#2
Camera-specific Development / Re: Canon 1200D
March 23, 2017, 03:49:01 PM
Hi a1ex,

I have recorded the installation, you can watch it here and see where it stops:  https://youtu.be/fLUH9sNVsFQ
The camera is not freezing when I get the blank screen, just power saving. When I press the shutter half way the menu comes back and ML stays active ( boot flag was set already earlier as I explained )
#3
Camera-specific Development / Re: Canon 700D / T5i
March 23, 2017, 08:22:36 AM
Hi Daniel,

I run ML now with firmware 1.1.4, how can I go over to 1.1.5 and install your build ?

Cheers,
Janos
#4
Camera-specific Development / Re: Canon 1200D
March 22, 2017, 01:18:36 PM
Hi a1ex,

I had already ML installed with the older installer, and I could do a format succesfully with ML preserved ( after executing your installer ).
#5
Camera-specific Development / Re: Canon 1200D
March 22, 2017, 08:42:40 AM
Hi A1ex,

I have tested your installer yesterday evening, it stops at the "EnableBootdisk" message, than the screen goes blank. Nothing happens after unless I switch the camera off/on, then ML starts. In my case I have enabled boot with EOScard.exe already earlier,

cheers,
Janos
#6
Camera-specific Development / Re: Canon 1200D
March 21, 2017, 09:20:00 PM
Hi,

I am looking forward to have the advanced intervalometer module available for the 1200D. Hopefully it doesn't take much effort to make it work on this camera.
Does anyone know if someone is working on it ?
#7
General Help Q&A / Re: firmware 700d
March 20, 2017, 08:54:31 PM
Hi,

Just a "basic" question: I have the latest nightly build on my 700d with firmware 1.1.4. What is the correct way to upgrade the camera to 1.1.5 Canon firmware and install ML for this firmware ? Do I need to uninstall ML first ?

Thanks for any help ;-)

#8
Hi developers,

First of all thanks for all efforts to make ML work on the700D;-). One of the main reasons I have installed it because I make astro timelapse videos.
After activating ML I don't see where can I do "bulb ramping" on this camera ? I thought I would find it under Intervalometer but it's not there. Am I overlooking something here ?

Cheers,
Janos
#9
Camera-specific Development / Re: Canon 1200D
March 18, 2017, 09:09:09 AM
Hi,

I could also install ML on my 1200D, it got stuck at the "EnableBootdisk" message first. So this was in the installer part I guess.
But after using the EOScard.exe utility on mySD card it works, thanks to all developers !

Cheers,
Janos