Hi,
I recently bought a 6D and was excited to use ML on it. Like an idiot, I tried to revert back to 1.1.3 from 1.1.6 just by updating. Some sort of error has occurred and I cannot get the camera to get out of the update procedure. I have yet to try to install ML so there has to be a way to fix this normally.
The camera will only boot to the update procedure (Firmware Update Program) and will not run normally. I've tried inserting a card to update from 1.1.6->1.1.6, it goes through the update and gives me the following error: "FIRMWARE UPDATE PROGRAM - Update File Error. Please check memory card and reload the battery and try again." I've had no luck with anything.
I've done with with multiple card, 16-32gb.
Please help!
I recently bought a 6D and was excited to use ML on it. Like an idiot, I tried to revert back to 1.1.3 from 1.1.6 just by updating. Some sort of error has occurred and I cannot get the camera to get out of the update procedure. I have yet to try to install ML so there has to be a way to fix this normally.
The camera will only boot to the update procedure (Firmware Update Program) and will not run normally. I've tried inserting a card to update from 1.1.6->1.1.6, it goes through the update and gives me the following error: "FIRMWARE UPDATE PROGRAM - Update File Error. Please check memory card and reload the battery and try again." I've had no luck with anything.
I've done with with multiple card, 16-32gb.
Please help!