Messages

If I remove the battery, take the card out, and replace the battery, it just tells me to insert a card with an update present. Cant do anything else.

I've tried doing the update process with many cards with 1.1.6 on them. If I go thorugh the process of updating i get the error, "FIRMWARE UPDATE PROGRAM - Update File Error. Please check memory card and reload the battery and try again."

I remove the battery (which restarts the camera) and try it again with a SD card without an update file on it, it tells me to insert a card with an update present. So I insert another card with 1.1.6 on it...same error as above. Its just a loop.

I cannot get out of the Firmware Update Program screens.

I cannot access any menus in the 6D. I turn it on and it searches for Update SD card and wont let me do anything else. :/
If I insert a card without an update on it: "Update file not found. PLease check memory card and reload the battery"

Hi,
I recently bought a 6D and was excited to use ML on it. Like an idiot, I tried to revert back to 1.1.3 from 1.1.6 just by updating. Some sort of error has occurred and I cannot get the camera to get out of the update procedure. I have yet to try to install ML so there has to be a way to fix this normally.

The camera will only boot to the update procedure (Firmware Update Program) and will not run normally. I've tried inserting a card to update from 1.1.6->1.1.6, it goes through the update and gives me the following error: "FIRMWARE UPDATE PROGRAM - Update File Error. Please check memory card and reload the battery and try again." I've had no luck with anything.

I've done with with multiple card, 16-32gb.

Please help!