for 6d and 650d has such a module?
Etiquette, expectations, entitlement...
@autoexec_bin | #magiclantern | Discord | Reddit | Server issues
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: Marsu42 on September 24, 2013, 12:08:12 PMя это знаю, просто не понял зачем тогда положили в эту сборку fir файл.
The ML .fir is *only* required *once* to enable using ml at all - from then on, just copy the appropriate files, mainly autoexec.bin & the modules to the card.
Quote from: dsagilles on September 16, 2013, 12:17:43 PM
I've also upload a timelapses compilation I've shot this summer :
Quote from: Rewind on September 05, 2013, 02:22:30 PMвсе работает спасибо!!!
http://www.magiclantern.fm/forum/index.php?topic=7139.0
read the first post.
Quote from: saha007 on September 05, 2013, 08:53:07 AMдержи земляк
where to find the help files? And how to install? It is desirable to Russian!...
Quote from: ERBUSI on September 05, 2013, 12:59:03 PMнужно удалить настройки МЛ, через меню ML сделать сброс конфигурации (Prefs-Config file-Restore ML defaults), или удалил файл MAGIC.CFG из папку :\ML\settings
ML_N_05.09.2013.zip to ISOless PH err(2):
Quote from: satriani on August 20, 2013, 03:21:12 PMтак понятно, без мл он работает и на на сборке от 18 числа он работает, а с новой сборкой от 19 не работает
Guys please, befor posting your issue
1. Remove autoexec.bin and ML folder from your SD and extract new build again to SD. Then test again.
2. If issue is not with ML, then start your cam without ML by press and holding SET while start the cam or better with other SD without ML. Test again.
And always tell which build you use!
У меня зум работает отлично. Попробуйте без ML.
Quote from: noisyboy on August 04, 2013, 05:21:54 AM[6D] AEValue2.zip it?
From the top [6D] zip file at the top of 1%'s Bitbucket
Replace files on your card from the ones in that zip.
Page created in 0.100 seconds with 14 queries.